# Do dry wells work in clay soil?

> A dry well needs soil that absorbs water, and most Irving clay barely does. When a dry well might work, how to test, and better outlets for clay lots.

URL: https://reinirvingdrainagecompany.com/guide/do-dry-wells-work-in-clay/

Guide

A dry well only empties by soaking into the ground around it. In tight clay it fills in the first storm and stays full, so the water you buried comes back.

## Key takeaways

- A dry well is a buried chamber that empties by letting water soak into the surrounding soil.
- Most Irving clay takes in water extremely slowly, so a dry well there usually stays full.
- On sand over clay, the well fills from the bottom up once it reaches the clay layer.
- A curb core, alley line, swale or pump is the usual outlet instead.

Usually not in Irving. A dry well empties by letting water soak into the soil around it, and the clay under most of Irving takes in water extremely slowly, so the well fills in the first storm and stays full. A dry well can help where a deep sandy layer sits below it. [Rein Irving Drainage Company](https://reinirvingdrainagecompany.com/) checks the soil first and usually designs a different outlet.

## How a dry well is supposed to work

A dry well is a storage chamber with leaky walls. A pipe from downspouts, a catch basin or a French drain carries water into it, the chamber fills, and the water seeps out through the sides and bottom into the soil. It works when the soil can absorb the water faster than storms deliver it, and empty the chamber before the next storm. It does not move water off the lot; it parks it underground and relies on the ground to take it.

That last part is the problem in clay.

## What Irving clay does to a dry well

The USDA soil survey describes conditions at sample points, not every lot, but the picture across Irving is consistent.

| Area (soil survey sample point) | What is in the ground | What a dry well does there |
| --- | --- | --- |
| Las Colinas | Ferris and Heiden clay, about 52 percent clay; hydrologic group D, the slowest-draining class | Fills and stays full; water backs up the inlet pipe |
| Central Irving near Irving Blvd | About 15 in of loamy fine sand over sandy clay loam | Water drains through the sand, stops on the clay and fills the well from the bottom up |
| Plymouth Park | About 8 in of sandy loam over 45 percent clay | The well sits almost entirely in clay |
| North and south Irving bottoms | Ovan clay and Frio silty clay, frequently flooded | Groundwater and floodwater can fill the well from outside |

Ksat is the rate water moves through soil that is already saturated. A low figure means water soaks in very slowly, and clay with a high plasticity index, like the 45 to 59 range at the Las Colinas sample point, also swells when wet, closing the pores that are there. A chamber in that soil holds whatever it receives for a long time. When the next storm arrives, the water has nowhere to go but back up the pipe, which can mean water overflowing at a downspout or a catch basin grate beside the house.

Sand over clay is a subtler trap. The top foot or so drains well, so a shallow test looks promising. But a dry well is deeper than that, and once it reaches the clay layer it is sitting in the same perched water that made the lawn soggy in the first place.

## When a dry well might work

A dry well can make sense where:

- A soil test shows a **deep sandy or gravelly layer** below the well, not just sandy topsoil over clay. Parts of the region, such as the Gasil sandy loam mapped at a Southlake sample point, have more sand, but even there it sits over sandy clay loam at about 17 inches.
- The well receives a **small, steady load**, such as one downspout from a small roof, not a whole yard.
- There is **no reachable outlet**, and an overflow is planned for when the well is full.

The only way to know is to test at the depth the well would sit. A shallow hole in sandy topsoil can give a misleading answer.

## What a dry well costs

As a national range, given here for context only, a dry well runs about $1,165 to $4,420. That buys a chamber that, in most Irving clay, will not empty between storms, so the money is better spent on an outlet that actually moves water.

## Better outlets for clay lots

| Outlet | How it handles clay | Notes |
| --- | --- | --- |
| Curb core | Sends water off the lot in solid pipe; soil does not matter | Often needs city approval; Irving’s rule is confirmed per address |
| Alley line | Same, where the lot backs onto a lower alley | Usually shorter than a run to the curb |
| Swale | Carries water on the surface along a property line | Needs steady fall and must not concentrate water on a neighbor |
| Pop-up emitter | Releases water to a lower part of the lawn | Works only where the lawn keeps falling away |
| Sump and pump | Lifts water to a legal outlet where gravity cannot | Needs power and periodic checks |

Each of these moves water rather than storing it. The [where a French drain can drain](https://reinirvingdrainagecompany.com/guide/where-does-a-french-drain-drain/) guide covers the city rules, including Texas Water Code section 11.086, which makes it unlawful to divert surface water in a way that damages another property. On a flat lot with no lower point, a [sump and pump](https://reinirvingdrainagecompany.com/sump-pump-drainage/) is usually the reliable answer, and the [sump pump drainage](https://reinirvingdrainagecompany.com/sump-pump-drainage/) page explains how one is built.

## Next step

If a dry well has already been installed and the yard still floods, the well is likely full. Check whether water stands in its inlet a day after rain. A [whole-yard drainage plan](https://reinirvingdrainagecompany.com/yard-drainage/) can reroute that pipe to a real outlet, often reusing the [catch basins](https://reinirvingdrainagecompany.com/catch-basins/) and [buried downspouts](https://reinirvingdrainagecompany.com/downspout-drainage/) already in the ground. For the wider picture, see [how to fix yard drainage problems](https://reinirvingdrainagecompany.com/guide/how-to-fix-yard-drainage-problems/), or [send your address and a photo](https://reinirvingdrainagecompany.com/contact/).

## Questions people ask

### What is a dry well?

A buried chamber, either a perforated plastic tank or a pit filled with stone, that receives water from a pipe and lets it soak slowly into the surrounding soil. It holds water for a while; it does not send it anywhere.

### How can I test whether my soil will drain a dry well?

Dig a hole to the depth the well would sit, fill it with water, let it drain once, then refill it and time how fast the level drops. If it barely moves over several hours, the soil cannot empty a dry well between storms.

### Do dry wells need maintenance?

Yes. Sediment from roofs and lawns settles in the chamber and seals the soil around it over time. An inlet filter or a catch basin upstream helps, and the chamber needs an access lid so it can be inspected and cleaned.

## Get an estimate

Tell us where the water stands and send a photo. After a site visit, you get a written price.

[(469) 680-8773](tel:+14696808773)

## Related service

[Yard drainage systems](https://reinirvingdrainagecompany.com/yard-drainage/)

## Related services

- [Yard drainage systems](https://reinirvingdrainagecompany.com/yard-drainage/)
- [Sump pump drainage](https://reinirvingdrainagecompany.com/sump-pump-drainage/)
- [Catch basin installation](https://reinirvingdrainagecompany.com/catch-basins/)

## Guides

- [Where a French drain drains](https://reinirvingdrainagecompany.com/guide/where-does-a-french-drain-drain/)
- [French drains in clay soil](https://reinirvingdrainagecompany.com/guide/do-french-drains-work-in-clay-soil/)
- [How to fix yard drainage problems](https://reinirvingdrainagecompany.com/guide/how-to-fix-yard-drainage-problems/)
- [Drainage cost in Irving](https://reinirvingdrainagecompany.com/guide/drainage-cost-irving/)

## Looking for somewhere to send the water?

Send your address and a photo of the wet area; we will work out the outlet first.